Atech Tech LIBRA-04 M Manuel d'utilisateur télécharger pdf (Page 11)

LIBRA-04 M MANUAL COPY ROUTER

11 / 19

IV.2 – THE REQUIRED OPERATION ZONE

ATech recommends a minimum of 100 cm (40”) clearance on the front, a minimum of 30

cm (12”) clearance at the back side of the entire assembly and a minimum of 150 cm

(59”) clearance on the sides.

The following figure shows the recommended minimum safe operation area.

Figure 4-2 The settlement of machine

IV.3 – INSTALLATION and ASSEMBLY OF

MACHINE

Ensure that the ground is even and level. Ensure that there is sufficient space

around the machine for easy maneuvering, safe operation and servicing / maintenance

access.

The electric connection of the machine has to be carried out by a qualified

electrician. Routing panel should be of high quality. A good grounding system is very

important because it will prevent possible electrical injury.

Voltage fluctuation, low and high voltage are very dangerous for the machine. Use

voltage regulator to prevent these problems. Otherwise, ATech is not responsible for

possible defects.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 17 18 19

Pas de commentaire

Atech Tech LIBRA-04 M Manuel d'utilisateur Page 11